Winnebago Chalet Specifikace stáhnout pdf (Strana 101)

10-5

SECTION 10 –

SLIDEOUT ROOMS

There are two slideout motors equipped on the

end wall of each slideout room. Pull back wipe

seal to access motors.

Push-In Procedure

1. Pull back wipe seal to access slideout motor.

2. Using a flat-head screwdriver, push bottom of

slideout motor UP to disengage

(approximately 1/2” from base).

Repeat on opposite slideout motor.

3. Push slideout room in to travel position,

ensuring both sides are relatively even.

NOTE: Several people may be needed to push

the room in.

4. When the slideout room is fully retracted,

secure the room with a support item (e.g. 2x4

wood board) above the interior slideout room

to secure room during travel.

NOTE: For larger slideout rooms, place a travel

support item on each end of the interior

slideout room.

Slideout Motor

(Located behind slideout wipe seal)

• Use a screwdriver to push slideout motor

UP (disengage).

• Ensure slideout motor is disengaged

approximately 1/2” from base.

Slideout Travel Support

• Place support item (e.g. 2x4 wood

board) above interior slideout room as

shown.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 127 128

Žádné komentáře

Winnebago Chalet Specifikace Strana 101